Cisco XR 12000 Series Getting Started Guide

3-63
Cisco IOS XR Getting Started Guide for the Cisco XR 12000 Series Router
OL-24755-01
Chapter 3 Configuring General Router Features
Managing Configuration Sessions
Examples
The following examples illustrate how to commit a configuration:
• Committing a Configuration from Global Configuration Mode: Example, page 3-63
• Committing a Configuration from Administration Configuration Mode: Example, page 3-63
Committing a Configuration from Global Configuration Mode: Example
In the following example, the default commit command is entered in global configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# interface POS 0/0/0/2
RP/0/0/CPU0:router(config-if)# description faq
RP/0/0/CPU0:router(config-if)# ipv4 address 10.1.1.1 255.0.0.0
RP/0/0/CPU0:router(config-if)# commit
RP/0/0/0:Aug 6 09:26:17.781 : %LIBTARCFG-6-COMMIT Configuration committed by user
‘cisco'. Use 'show configuration commit changes 1000000124' to view the changes.
Note The preceding message is stored in the log and appears only if logging is configured to display on screen.
Committing a Configuration from Administration Configuration Mode: Example
In the following example, the commit command is entered with the label and comment keywords in
administration configuration mode:
RP/0/0/CPU0:router# admin
RP/0/0/CPU0:router(admin)# configure
RP/0/0/CPU0:router(admin-config)# sdr test
RP/0/0/CPU0:router(admin-config-sdr:test)# location 0/1/* primary
RP/0/0/CPU0:router(admin-config-sdr:test)# commit label test comment This is a test
RP/0/0/CPU0:router(admin-config)# show configuration commit list detail
1) CommitId: 2000000018 Label: test
commit force (Optional) Merges the target configuration with the running
configuration and allows a configuration commit in low-memory
conditions.
A low-memory warning occurs when a user attempts to commit a target
configuration that exceeds the default capacity of the router.
The recommended resolution to such a warning is to remove
configurations using the no commands.
Caution The force option can cause the router to experience severe
problems if low-memory conditions occur. The force option
should be used only to remove configurations.
commit replace (Optional) Replaces the contents of the running configuration with the
target configuration.
Table 3-5 Commit Command Options (continued)
Command Description

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English