— 87 —
ESC c 3 n
[Function] Selecting the Paper Sensor valid for a paper end signal output
[Code] <1B>H<63>H<33>H<n>
[Range] 0
n 255
[Outline] This command selects by which Paper Sensor a paper end signal
should be output. Each bit for “n” has the following meaning:
Bit Position
Value
01
0 Paper Near-end Disabled Enabled
1 Paper Near-end Disabled Enabled
2 Paper end Disabled Enabled
3 Paper end Disabled Enabled
4 Undefined
5 Undefined
6 Undefined
7 Undefined
[Caution] This command is valid only for the parallel interface.
The bit0 and 1 are ignored when using the label paper.
[Default] n = 15
n = 12 (When using the label paper)
To Next Page
Loading...
Need help?
General
