— 22 —
Starting hexadecimal dump
1
Open the top cover.
2
While pressing the FEED switch, turn
on the power of the printer “
➀”.
3
When you close the cover “➁”, a
message “Hexadecimal Dump” is
printed on paper, and then the data
received afterward is printed in
hexadecimal numbers and the
corresponding characters.
• If a character is not available
corresponding to the data received,
“ . ” is printed instead.
• During hexadecimal dump, no
other functions than DLE EOT and
DLE ENQ work.
• If the data received is not enough
for a full line, pressing the FEED
switch causes the line to be
printed.
<Example of hexadecimal dump>
Quitting hexadecimal dump
4
After hexadecimal printing, this
function is terminated when you
turn off the power or when a reset
signal is received from the interface.
1
2
1
4.10 Hexadecimal Dump
=== Hexadecimal Dump ===
Hexadecimal dump function allows data sent from the host computer to be printed in
hexadecimal numbers as well as in characters corresponding to the numbers.
To Next Page
Loading...
Need help?
General
