— 80 —
ESC S
[Function] Selecting STANDARD MODE
[Code] <1B>H<53>H
[Outline] Switches from PAGE MODE to STANDARD MODE.
[Caution] • This command is only effective if it is entered when in PAGE
MODE.
• Any data mapped in PAGE MODE is erased.
• After this command is executed, the beginning of the line is
taken as the next print start position.
• The print area defined by ESC W is initialized.
• The commands listed below, which have separate settings for
STANDARD MODE and PAGE MODE, are changed to the
settings for STANDARD MODE use.
(1) Spacing setting: ESC SP
(2) Line feed width setting: ESC 2, ESC 3
• STANDARD MODE is selected when the printer is turned on
or reset,or when ESC @ is executed.
[See Also] FF, ESC FF, ESC L
To Next Page
Loading...
