- 21 -
9.2. Choice of criteria of stable result depending on conditions of using
Press key TARE. When horizontal lines appears on display press key CAL.
Then press F key many times until order Con
appears on display
• Press PRINT key. Next to Con settled value of parameter with flashing
number is displayed. Flashing number means stage of average result
• By pressing key F change value of flashing number choosing
one of the stages of averaging.
• Press PRINT key to confirm setting
If the conditions of work are good value Con should be settled on level 1÷2.
If the conditions are worse (drafts, breeze of air) set value on 5.
Notice:
If user increases this parameter time of waiting for stable result is longer. If the
conditions of work are bad and value Con are big scale cannot get stable result.
But if value Con is too low for bad conditions scale doesn’t get stable result (STAB
lights on and off on display).
To Next Page
Loading...
Need help?
General
