- 4 -
2. APPLICATION
Electronic scale CY - CG is appropriate for precise measurements mass in
laboratory conditions with possibility of setting to zero in all measure range. Balance
calibration is done by CAL on balance keyboard.
Functions accessible to user are divided into 4 parts:
! Functions for weighing units (press F key)
- Weighing in grams,
- Result with 3 places after dot,
- Weighing in carats [ct],
- Weighing in units from beyond SI: [GN], [mom], [oz], [dwt]. Access to
these units is blocked from factory menu level.
! Functions for calibration and weighing modes
(tare key + f key)
- Summing function
- Counting pieces
- Control of deviations % according to standard mass
- Thickness of liquids
- Thickness of solids
! Choice of criteria of stable result depending on conditions of using
(tare key + cal key)
- Turn off/on system of autozero
- Summing function
- Turn off / on automatic calibration in relation to changes of temperature
- Turn off/ on automatic calibration in relation to time from last calibration
- Setting amount of average measurements
- Average result of weighing
- Adjusting balance for dosage procedure
- Select default unit of weighing
! Function for using RS 232
(tare key + print key)
- Choose speed of transmission
- Define sent data as: stable / not stable
- Continuous work
- Setting data as additional element of parameter in printouts
- turn on/off marking of last digit in printout
Moreover balance can be used to weigh hang loads, print report of
calibration, check deviation of calibration and print reports of testing
thickness of liquids and solids.
To Next Page
Loading...
Need help?
General
