- 33 -
Give any result of weighing
12. REPORTS FROM SCALE
Scales with internal calibration can control parameters remembered in memory very
fastly. Their function can be increased. Their service functions can be done easily.
12.1. Current control of calibration fault
Described function is usefull if during long measurement user wants to be sure that
results don’t have bigger errors than terror shown on display.
When scale is in autozero zone (ZERO) press keys TARE and F at the same time.
Balance starts autotest for control. Display shows calibration mass. Put the load on
the pan. At the moments, scale show compares result of weighing with declared
value of calibration mass. Difference between these two sizes is shown on digital
display. Press TARE – return to weighing
To Next Page
Loading...
Need help?
General
