3- 2
3-2 Connecting to Detector
Caution
■
Keep the power OFF during wiring work.
Be sure to keep the power OFF when inserting a cable into or removing it from a
detector. Performing these operations with the power ON may result in electric shock or
failure.
Insert the controller connector of the detector cable into the detector cable connector of the controller.
After checking the orientation of the connector, push it in firmly as far as it will go.
To remove, press the lock release lever on the detector cable controller connector, hold the body of the
controller, and—whilst keeping the lever pressed—pull out the connector.
Please note that, when removing the connector, pulling the cable without pressing the lock release
lever may result in the cable breaking off or the connector being damaged.
Insert
Lock release
lever
To Next Page
Loading...