6- 44
6-3 Calculation Settings (Master Unit Only)
6-3-1 Calculation Mode
Parameter name Setting value Remarks
Calculation mode (MODE)
This mode carries out calculations using measurements from
each connected controller, and outputs the judgment results on
the master unit display and from the master unit.
CALC (Calculates) / NOCALC (Does not calculate)
[Default: NOCALC]
Select calculation app (APPLI)
The Select calculation app can be set when calculation mode is
set to CALC.
This selects the application used for the calculation.
MAX (Maximum)
MIN (Minimum)
FLAT (Flatness)
AVERAG (Average)
STAND (Difference from standard)
TORSIN (Torsion)
CURVEA (Curvature)
THICK (Thickness)
[Default: MAX]
Operation procedure
for 2 s
Select
Cancel
Select
Commit
To Next Page
Loading...