76
Operating Manual
5. The rst pull – positioning corrections
For creasing, diecutting and perforating jobs please check once more if:
a) the offset printing plate is removed;
b) the screen roller/coating roller is removed when used in the coating unit;
c) the printing pressure setting is correct, “Start with an blanket to impression cylinder
spacing of 0.35 mm and adjust if necessary!“
d) ink ductor, dampening form and inking form rollers are switched off!
After base plate and grid sheet are clamped correctly and the protective impression cylin-
der jacket has been afxed to the impression cylinder, the press is now ready for the rst
pull. In order to test the position of the assembled RSP form a rst test pull is made now.
Adjust the printing pressure accordingly step by step.
Important note:
You must not use the automatic blanket washing device or impression cylinder
washing device in the printing/coating unit where you are using the RSP System 2.0!
To Next Page
Loading...