clare H101 - Test Code Tables

Test code Tables
Seaward Test codes are an 11-character string where each character
is in the ASCII range ‘0’ to ‘9’ and ‘A’ to ‘Z’. The character count starts
from left to right. The example below shows Z as digit 1 or (character
no. 1) and the integer 1 as digit 2 (character no. 2) and so on.
e.g. Z1234567890
Digit 1 (Character 1) – Test code Type
Digit 1 associates the test code with Seaward Group Ltd. Equipment
Digit 1 : Test code Type
‘Z’ Seaward Group Ltd. Test code
Digit 2 – Test Type
Digit 2 represents the type of test to be performed. On the H102 it also
encodes the status of H102 c
channel 1
– only relevant if the test code is
at the top of a loop. If no channels are explicitly encoded for use then
channel 1 will be used.
H101
Digit 2 :
Test Ty
pe
‘0’ Skip Test
‘1’ AC Hipot 50Hz
‘2’ AC Hipot 60Hz
‘3’ DC Hipot
‘4’ DC Insulation Resistance
‘5’ – ‘9’ Not Used
‘A’ – ‘Z’ Not Used
d ‘A
’ to ‘Z’.
belo
w shows Z
2 (character n
de T
ring where eac
The characte
as digit 1 or (c
2) and so on.
h character
ount starts
aracter
Digi
Z
t 1 (C
12345
eger 1
5678
‘4’
‘5’ – ‘9’
– ‘Z’
AC
AC
DC H
DC Ins
N
Not
re exp
T
e
s
t
T
ed. On t
y relevant if th
citly encoded
e H102 it also
e test code is
r use then
p Ltd. T
est code
Group L
Ltd. Eq