clare H101 - Change Password; Set Brightness; Factory Settings

Change Password
It is possible to Password protect the Test Sequence Editor and the
Country Settings.
If you currently do not have password protection you will be asked to
enter a new password twice, once for confirmation.
If you currently do have password protection then you will be asked for
the old password before entering a new one, again you will be asked
for the new password twice.
To clear the password protection, simply press Enter when asked for
the new password. A warning will show that no password is in place.
Set Brightness
You can now set the Brightness of the display. Use the encoder to
change the Brightness, once the Brightness is set press the Green
button to accept the changes. Press the Red button to abort any
changes made.
Factory Settings
It is possible to reset the Hal to the settings that were configured from
new. This option will first ask you if you are sure, select ‘Yes’ to reset or
press CANCEL to Abort.
ord prote
nce for confirm
rd pr
otection
a new on
mply
uence Ed
tion you will
ation.
en you will be
in yo
or and the
asked to
To c
the ne
p
he new
lear the
ntly d
ssword
w passw
o have
befo
ord
hat were con
sure, select ‘Y
figured from
s’ to reset or
ce the B
es. Pre
of the d
Brightne
ss the R
isplay. U
ess is s
Use the
rd