Cleco CellCore - Torque Test

Menus and Functions
36 P2398PM | 2018-12 Apex Tool Group GmbH
3
EN
 To start the tests, keep the Start switch pressed.
> >
Abb. 3-25: Submenu – Angle test
3.9.3 Torque test
With the torque test, the functionality of the measuring sensor can be checked and the torque measurement
can be evaluated. At the beginning of the test, the torque is 0 Nm. Throughout the entire test, the torque is
measured and displayed.
 To start the tests, keep the Start switch pressed.
> >
Symbol Description
Display of the shut-off angle of 360°.
Display of the angle.
The displayed angle should be close to 360°.
360
362