Cleco CellCore - Menus and Functions; General Functions; Switching on; Switching off

Apex Tool Group GmbH P2398PM | 2018-12 9
Menus and Functions
3
EN
3 Menus and Functions
3.1 General functions
3.1.1 Switching on
To switch on the tool, press the Start switch.
3.1.2 Switching off
There are several ways to switch off the tool.
Option 1:
Remove the battery.
→ Tool switches off after 20 seconds.
Option 2:
1. Navigate to Switching the tool off:
> >
2. Press the button.
→ The symbol is displayed on the LCD.
→ After five seconds, the tool switches off.
Option 3:
The tool will switch off if it is not used for a certain time. See Setting the shut-off properties, Seite 28.
3.1.3 Selecting a button
When talking about pressing a button in this manual, this means the following:
1. Use the arrow buttons to navigate to the desired button (outlined in blue).
2. Press the button.
3.1.4 Changing parameters
1. Press the button.
2. Change the number using the arrow buttons.
3. Confirm with the button.