Cleco CellCore - Software Update

Apex Tool Group GmbH P2398PM | 2018-12 47
Menus and Functions
3
EN
To save the parameters:
1. Connect the USB stick with the tool via the Micro B USB cable.
2. Navigate to Saving parameters:
> >
3. must be pressed to start the saving process.
→ The progress bar and status bar indicate when the data are saved.
→ A password-protected file is generated: parameters_(DateTime).zip
3.11.6 Software update
> >
Abb. 3-38: Submenu – Software update
Button Description
Start the software update.
Display of the software update progress.
The progress bar indicates what percentage of the software is already reached.
Display of the software update status.
After the software update, the status bar is red or green:
• Green: The software update was successfully completed. There is an "OK" in the
status line.
• Red: An error occurred during the software update. See Error messages, soft-
ware updates and data storage, Seite 52.
0%
0