Modules
Setting Up SATA RAID or AHCI Mode 7 - 5
7
1. Go to the operable computer and insert a USB Flash drive or external USB hard
disk.
2. Insert the Device Drivers & Utilities + User’s Manual disc into the CD/DVD drive
of the operable computer.
3. Copy the f6flpy-x86 or f6flpy-x64 folder from the location below (D: denotes your
DVD drive) on the Device Drivers & Utilities + User’s Manual disc to the USB
flash drive or external USB hard disk.
• For Windows 8 32bit = D:\Options\00_IRST\f6flpy\f6flpy-x86
• For Windows 8 64bit = D:\Options\00_IRST\f6flpy\f6flpy-x64
4. Start-up your notebook computer and press <F2> to enter the BIOS.
5. Go to the Boot menu, select UEFI Setting and press <Enter> (see page 5 - 14).
6. Set UEFI Boot to “Enabled”.
7. Press <Esc> to exit the menu and go to the Advanced menu.
8. Select SATA Mode (see page 5 - 10), press <Enter> and select “RAID Mode”.
9. Press <F4> and <Yes> to “Save Changes and Reset”.
10. After computer restarts press <F2> to enter the BIOS again.
11. Go to Intel(R) Rapid Storage Technology (in the Advanced menu) and press
<Enter>.
12. Select Create RAID Volume and press <Enter>.
Figure 7 - 1
Create RAID Volume
(Advanced > Intel(R)
Rapid Storage
Technology
To Next Page
Loading...
