CM Lodestar A - Functions Leds; Parameters

17
P/N: 10001609 (REV AB) 627NH December 2014
FUNCTION LEDS
NO. Display Lit Flashing OFF
12
When the drive detects
an alarm or error
When an alarm occurs
OPE detected
When a fault or error occurs
during Auto-TUning
Normal state (no fault or alarm)
13
When the REVERSE
command is given
—
When the FORWARD
command is given
14
Drive Ready Auto-Tuning — Programming Mode
15 Displays output frequency (Hz) — —
paRameteRs
There are hundreds of parameters, organized by function group, that determine how the drive functions. These parameters are programmed
in the drive’s software as measurable values or options-both of which will be referred to in this manual as settings. While some of these
parameters are associated with one setting, others are tied to a number of possible settings.
The IMPULSE•G+ Mini is congured for a specic hoist or trolley. If you nd it necessary to change the initial settings, it is recommended
that you only allow qualied system technicians to program the drive. This can be accomplished by using the Password and Access Level
features. The factory must be contacted.