of 509
c. Select Change Set Up, Press START/OK key
d. Scroll down to option “More”, Press START/OK
e. For BodyGuard 323 Enter Change Set Up Code
f. Scroll to option History, Press START/OK key.
g. Using arrow key scroll through events, Press INFO key for
more detail.
h. Exit by pressing start/OK key
BodyGuard 545, & 575
a. Start pump normal operation mode
b. Enter Level 1 code, Press START/OK to enter Main Menu
c. Scroll down to Event Log, Press START/OK
d. Using arrow keys scroll through events, Press INFO key for
more detail.
e. Exit by pressing START/OK key
Manual Review of Pump settings
a. Enter the Technician Menu (power up the pump while holding
down the INFO & POWER keys simultaneously until the
Technician Code prompt appears).
b. Enter Technician Code.
c. Scroll to ‘Manual Calibration’ and record all pump calibration
settings (volume and pressure calibration) by pressing
START/OK continuously to review each setting.
d. Scroll to and perform ‘Main Self-Test’ and record any failures
or issues identified during the test.
6. Review Customer supplied Service Request Information
a. Has the user operated the pump correctly? Cross reference their report
with the Operation’s Manual to ensure the steps they took prior to the
incident did not cause, or result in, an alarm state or error code.
7. When the Pre-Service checklist has been completed, begin Service by
performing the Operational Checklist.
a. If a charger was returned as a complaint item, test the charger with the
associated pump cited in the complaint. If no pump was returned with
the charger, process the charger as usual.
To Next Page
Loading...
Need help?
General
