Setup with the web interface for PC
98-144390-C Chapter 4: Setup and operation 4-13
2. For each item under ALLOW USERS TO: select
• Yes to give the guest user access to the settings.
• No to block the guest user access to the settings. Then the pages are read-only,
changes cannot be made by the guest user.
Change network: Locks the page SETTINGS > Network. On this page IP configuration
of the LAN connectors can be changed. For further information see To configure the
LAN network on page 4-7.
Modify LNB data: Locks the page SERVICE > LNB for guest users. This page is used
when exchanging an LNB.
Control Modem: Locks the page SERVICE > Modem for guest users. This page is used
to reset or power cycle the GX modem.
3. Click Apply.
4.1.8 Import and export of a system configuration
The configuration file contains all the settings you have entered during system setup:
satellite profiles, VSAT modem profiles, LAN setup, user permissions etc. If you need to
reuse a configuration in another EXPLORER 3075GX, you can save the current configuration
to a file, which can then be loaded into another EXPLORER 3075GX. You can also use this
feature for backup purposes.
Figure 4-9: Web interface: ADMINISTRATION, User permissions
You can only load and save configurations when the units have the same
software version.
The configuration file contains the encryption key of the WLAN.
To Next Page
Loading...
Need help?
General