COBHAM Explorer 710 - Page 116

Chapter 4: To use the web interface
98-140012-H Advanced settings 107
the filter will automatically route UDP data traffic to the connection type associated
with this traffic flow filter.
• Use local port filter.
This is a range of local port numbers on the terminal. The filter will route traffic to and
from any of these port numbers to the connection type associated with this traffic flow
filter.
• Use global port filter.
This is a range of global port numbers on the terminal. The filter will route traffic to and
from any of these port numbers to the connection type associated with this traffic flow
filter.
•Use type of service filter.
Type of Service (TOS) is used to define the Quality of Service. Set this value to a number
between 0 and 255.The filter will route traffic with this Quality of Service to the
connection type associated with this traffic flow filter.
• Use IPsec SPI filter.
IP security. The filter will route traffic using the Security Parameter Index (SPI) stated
here (in hexadecimal numbers) to the connection type associated with this traffic flow
filter.
7. Click Save.
The new filter will now be available for selection when you add new connections to a
connection package. Note that you can only select one filter per connection.
Example: You want a connection package, which allows you to use uninterrupted Voice over
IP while having a Standard data connection for web browsing etc. Do as follows:
1. Create a filter template with
• Protocol=UDP (Use protocol number filter)
• Type of Service = 0xb8 and Type of Service mask = 255 (Use type of service filter)
The UDP protocol is suitable for UDP voice streaming and the TOS value 0xb8 is used by
some linksys Voice over IP adapters.
2. Create a connection package as described in Multiple data connections on page 82.
3. Add a connection, e.g. Streaming 32 with the new filter you created in step 1.
4. Add a Standard connection with No filter.
Help desk
Under Help desk you can enter the contact information you want for your EXPLORER 710. The
Help desk contact information is empty by default. You must provide the contact information,
e.g. the phone number for your Airtime Provider. Do as follows:
1. In the Advanced page, select Help desk.
2. Type in the contact information you want.
3. select Save.
The Help desk information is now available from the About page (
 (Control panel) >
Support > About).