Installation check list: Functional test in harbor
7-4 Chapter 7: Installation check 98-141779-G
7.3 Installation check list: Functional test in harbor
Step Task Further information Done
1.
Check that the antenna is
tracking the satellite
The logon LED in the ACU display must be steady
green and the display must show: TRACKING.
Check in the web interface:
DASHBOARD:
System status: Tracking (see Connecting to the
web interface on page 6-1).
2.
Check that the modem is in lock
and BUC TX on.
In the web interface check:
DASHBOARD, RX locked status must show
Locked.
The ACU display must show MDM:NETOK
3.
Connect a user PC LAN (not the
service PC) to the Internet LAN
connector 2 of the ACU
The modemmodem needs no separate setup. See To
connect the ADU, ACU and modem on page 3-25.
4.
Make sure that the computer has
no access to the Internet through
other means (Wifi, 3G, 4G etc.).
Open a command line window
and type: ping 4.2.2.2.
Check that you get a response.
5.
Make sure that the computer has
no access to the Internet through
other means (Wifi, 3G, 4G etc.).
Open a web browser and browse
to e.g. www.google.com.
Check that the web page is downloaded.
6.
If step 4 is successful and step 5
is not then it seems that the DNS
is not configured correctly.
See the page SETTINGS > Network and check the
DNS setup (see To configure the LAN network on
page 6-24.
Table 7-3: Installation check list: Functional test in harbour
To Next Page
Loading...
Need help?
General
