COBHAM SAILOR 100 GX Installation Manual

Supported commands
E-10 Appendix E: Command line interface 98-141779-G
E.2.11 zone
Command Description
zone
Shows the sub commands, unit and
description for the command zone.
zone <id> azimuth <start
angle> <end angle>
Sets the azimuth angles of the blocking zone
for one zone.
• Valid zones: 0 to 7
• Valid angles: 0 to 360
zone <id> elevation <start
angle> <end angle>
Sets the elevation angles for a blocking zone.
• Valid zones: 0 to 7
• Valid angles: 0 to 360
zone <id> tx_off <yes | no>
Enables or disables TX inside the blocking
zone.
zone <id> active <yes | no>
Enables or disables the blocking zone.
zone <id>
Shows the setting for the blocking zone.
Table E-12: UCLI command: zone

COBHAM SAILOR 100 GX Specifications

General

Brand	COBHAM
Model	SAILOR 100 GX
Category	Marine Equipment
Language	English