List of events
98-141779-G Appendix D: System messages D-11
DDDD
0A062-0 Antenna WARNING High elevation The antenna cannot perform acquisition in gyro-free
mode because the elevation is too high.
0A063-0 Antenna WARNING BCM warning The BCM has observed an unusual situation with
regards to the PLL. If the situation persists, check the
BCM.
0A064-0 Antenna ERROR BCM communication Communication error between PCM and BCM. Check
SUB-D connectors and cables.
0A065-0 Antenna ERROR Deploy/Stow Deploy/stow error. The antenna did not properly
unlock (deploy), or the stow switch never closed
(stow).
0A066-0 Antenna ERROR OMT error Problem with OMT. Temperature out of range or OMT
cable may be broken.
0A067-0 Antenna WARNING Automatic stow The antenna automatically stowed because it
detected significant movement.
0A068-0 Antenna WARNING Polarisation tuning Polarisation tuning was not successful. Polarisation
may be incorrect.
0A069-0 Antenna ERROR BCM error The BCM PLL failed to initialize.
0A06A-0 Antenna WARNING Missing BUC response No response received from the BUC.
0A06C-0 Antenna FATAL Antenna base tilt Antenna base tilted beyond limit.
0A06D-0 Antenna WARNING VMU reference
distribution
VMU reference signal not present at BCM, but is
present at ACU. Check coax cable between VIM and
BCM.
0A06E-0 Antenna WARNING Antenna orientation The terminal is oriented in a way that prevents it from
pointing to the selected satellite.
0B000-0 PSM ERROR PSM production data Missing or invalid production data in the PSM. Replace
it.
0B001-0 PSM ERROR NMEA 2000 identifier Missing or invalid production data in the PSM. Replace
it.
0B010-0 PSM ERROR PSM link/SW version Link to the PSM module could not be established.
Either the PSM board is malfunctioning, or - if the
system software has just been updated - the software
is too old and is not compatible with the PSM
hardware.
Error code Unit Severity Description Explanation
Table D-1: List of events (Continued)
To Next Page
Loading...
Need help?
General
