Calibration
6-10 Chapter 6: Configuration 98-141779-G
Automatic azimuth calibration with an active satellite profile
You can enable automatic azimuth calibration, even if there is no line of sight to an azimuth
calibration satellite or GX service satellite from the place of installation. To be able to use
this feature you must have made a valid satellite profile and activate it. When the vessel
leaves the harbour and gets line of sight to the GX calibration satellite, the system
automatically finds and tracks the satellite and makes the azimuth calibration. After a
successful azimuth calibration the ACU will automatically disable the Azimuth
calibration (active satellite profile) on the page SERVICE > Calibration.
1. Create a modem profile, see Modem profiles on page 8-14.
2. Create a satellite profile, see Satellite profiles on page 8-13.
3. Click SETTINGS and Activate the satellite profile.
4. Click SERVICE > Calibration.
6 No signal received. Check that there is free line of sight. Try again or try with
another satellite.
7 RF setup error, e.g. missing or invalid TX frequency.
8 Invalid satellite, e.g. satellite not visible.
9 Unknown error
Error code Explanation
Table 6-4: Possible error codes during calibration (Continued)
Figure 6-7: Web interface: SERVICE, Calibration (example)
To Next Page
Loading...
Need help?
General
