To Next Page

To Previous Page

Sending calls

4-4 HF SSB transceiver user guide

Before you can send an ALE call, you need to:

• connect an ALE controller and set the correct RS-232

and baud rate settings (refer to the HF SSB transceiver

reference manual, Chapter 11, Connecting ancillary

equipment)

• make sure that the station you are calling is also set up

for ALE calling

• set up your address (refer to the HF SSB transceiver

reference manual, Chapter 8, Selcall address setup)

• set up your alphanumeric address if you intend to call an

alphanumeric address (refer to the HF SSB transceiver

reference manual, Chapter 5, ALE alphanumeric

address setup)

• set up a channel for selcalling (refer to the HF SSB

transceiver reference manual, Chapter 3, Channel

creation and editing)

• set up a scan table for ALE call scanning (refer to the

HF SSB transceiver reference manual, Chapter 3, Scan

table creation).

To send an ALE call:

Action Notes

Normally the

transceiver will be in

ALE Scan mode.

Example of the display when in

ALE Scan mode:

208

5820

CALL

Rx.

USB

ALE Scan

TYPE