Colop e-mark - General Safety Instructions and Provisions; Safety Notice Panels on the Product

e-mark marking device Chapter 2 Safety
CODI Standard 1.0 Page 14 of 61
Operating and Maintenance Manual
2.4 General safety instructions and provisions
Without exception, observe the following safety provisions and obligations when working at or on the
product:
 Always operate the product in operationally perfect and clean condition.
 It is prohibited to convert or modify the product.
 Faults must be remedied immediately.
 Always use genuine spare parts for repair work or when replacing damaged components.
 Always pay careful attention to the safety notices and operating instructions.
2.5 Safety notice panels on the product
Safety notice panels are fitted to the product to draw attention to potential hazards. Always pay attention
to and comply with the safety designation instructions on the product. During the service life of the product,
if the safety designation label fades or gets damaged, you must shut down the product.
The pictograms for warnings, prohibitions and stipulations on the product, together with their meaning:
Pictograms
Location
Designation
Description
Underside
Marking device
Warning: hot
surface.
The print head surface may become hot. Do
not touch the print head!
Underside
Marking device
Prohibition: Do not
touch.
Do not touch the print head!
Battery,
cartridge,
e-mark
Indications on
disposing of
electronic waste
Dispose of the appliance in accordance with
legislation and recycle wherever possible.
Battery
Indications on
handling batteries
Do not disassemble or modify, do not short-
circuit, do not dispose in fire and do not
expose to high temperature
Do not disassemble
or modify
Do not short-circuit
Do not dispose in fire
Do not expose to high
temperature