Colop e-mark - Maintenance and Care of the COLOP e-mark; Charging the e-mark Battery

e-mark marking device Chapter 6 Maintenance
CODI Standard 1.0 Page 45 of 61
Operating and Maintenance Manual
6 MAINTENANCE
The following sections describe the tasks required for maintenance purposes.
Inspection:
An inspection is required to ensure proper maintenance is carried out on the device. For more details on
visual inspection and performance inspection at initial start-up, see chapter 4.
 Product cleanliness (general condition, damage, contamination)
 Check the e-mark housing, docking station, charger and cable, USB cable, LED light bar, contacts
and battery for any obvious signs of damage or excessive dirt etc.
 If any damage is detected, stop using the product. If damaged, please contact your distributor.
6.1 Charging the battery
Check the charge indicator light on the LED Light Guide (see chapter 5.3):
- The rear LEDs flash red when battery charge is lower than 10%
NOTICE
The battery must not be deep discharged. This may cause damage. Fully
charge the battery before an extended downtime period.
Proceed as follows to charge the device battery:
 Remove the charging cable from the packaging and unwind.
Fig. 38: Power plug
WARNING!
Hazard from rechargeable batteries (short-circuit, overheating, fire).
Only use charging systems as recommended by the manufacturer. The battery
must not be deep discharged!
The battery must not be short-circuited. Fire risk!
 Connect the charging cable to the docking station.