Colop e-mark - Principle

e-mark marking device Chapter 1 Introduction
CODI Standard 1.0 Page 8 of 61
Operating and Maintenance Manual
Target groups and previous knowledge
Users of the e-mark are non-professionals, aware of the hazards associated with using the device via the
safety pictograms on the e-mark and instructions in the Quick Setup Guide and in this Operating and
Maintenance Manual. Users are able to recharge the e-mark with the power adapter (supplied) and replace
ink cartridges. Users are not authorized to carry out repairs on the product.
Inspection and maintenance and/or repairs must only be carried out by qualified electricians.
The content and purpose of this documentation
Users can download this original Operating and Maintenance Manual at www.emark.colop.com for
information.
This documentation contains the relevant information for e-mark assembly, commissioning, operation,
maintenance and disposal. This documentation is intended to ensure hazard-free work with the e-mark.
Compliance with the instructions contained within this document enables hazard-free working and avoids
damaging the e-mark.
Limits of use
The limits of use for the e-mark are defined as follows:
 The device is intended for use in enclosed, clean and dry areas (offices, warehouses, private
residences)
 Horizontal place of use on level, firm ground
 Ambient temperature: +15 °C to +35 °C
 Humidity range 5 % to 100 % (storage 5 % to 80 %)
 The e-mark is a marking device to stamp imprints sent via a software application
 It can mark directly onto a variety of absorbent surfaces including standard paper, cardboard, fabric,
wood, cork, dry wall, high-gloss paper, photo paper and other surfaces with special coatings.
 The e-mark is fitted with an LED light strip.
 The rechargeable battery of the e-mark is recharged using the power plug.
1.4 Principle
This product incorporates state-of-the-art technology and complies with applicable health and safety
regulations. Nonetheless, the following hazards can arise as a result of incorrect transport, improper use,
or failure to observe the safety instructions contained in this Operating and Maintenance Manual or in the
event of misuse:
 fatal or serious injury to users or third parties
 damage to the product and other items of capital equipment
 impairment to the efficient operation of the product