e-mark marking device Chapter 4 Initial operation
CODI Standard 1.0 Page 22 of 61
Operating and Maintenance Manual
Preparing for transport
Preparing the e-mark in its original packaging for transport. See below before sending or transporting the
e-mark:
1. Remove the rechargeable battery (see chapter 4.2).
2. Protect the battery contacts against short-circuit with insulating tape.
3. Return the battery back to the housing.
4. Return the e-mark to the original packaging (1) and secure it with the foam ring (2).
Fig. 7: Packaging
4.2 Assembly and switching on
Check the following points before commissioning:
Visual inspection:
Ensure that the Quick Setup Guide is legible, and is available in full.
Are all product parts present (see chapter 3.1)?
Are all parts required for assembly present?
To Next Page
Loading...
