e-mark marking device Chapter 5 Operation
CODI Standard 1.0 Page 28 of 61
Operating and Maintenance Manual
5 OPERATION
The product is designed for printing stamp templates and marking.
Online mode: The e-mark is controlled using software. Imprints can be loaded or created via the software,
transferred to the e-mark and then printed. The software application (App) displays status symbols for the
e-mark, including battery charge level, ink level, cleaning cycle request etc. Details can be found in the
software description.
In offline mode the e-mark is ready to print previously uploaded images at any time. Operating modes
are displayed via the light guide (see chapter 5.3). Every printing operation follows these steps in the
sequence below:
1. Switch on and wait until ready (Light Guide, see chapter 5.3).
2. Take the e-mark out of the docking station.
3. Wait until completion of the automatic self-cleaning cycle (see chapter 5.4).
4. Place onto the paper (or the printable background) and slide to the right or left (see chapter 5.2).
5. Printing starts and a signal sounds when the end position is reached.
6. Return the e-mark to the docking station immediately.
If the print quality is unsatisfactory, complete a manual cleaning cycle (wiping, see chapter 5.5).
ALWAYS place the e-mark in the docking station after use. Otherwise, the ink
cartridge head dries out, affecting print quality. A warning signal sounds if the
e-mark is switched on and not placed in the docking station for a certain time.
Return the e-mark to the docking station immediately. If the e-mark is switched
off, NO warning signal sounds, but the e-mark should always be placed in the
docking station even if switched off.
Sleep mode:
If the e-mark is switched on and is not used for 3 minutes, the device goes into sleep mode. If the e-mark
is placed in the docking station, it automatically goes into sleep mode.
Warning mode:
If the e-mark is not in the docking station and is not used for one minute, a warning signal sounds to
prevent the print head from drying out. The Light Guide (see chapter 5.3) flashes red and a warning signal
sounds. Please return the device to the docking station immediately.
To Next Page
Loading...
