e-mark marking device Chapter 5 Operation
CODI Standard 1.0 Page 44 of 61
Operating and Maintenance Manual
Fig. 36: Example image of WIFI connection in the settings of the mobile device
The e-mark is now connected by WIFI to the mobile device.
5.8 USB cable connection
The e-mark can also be connected via the USB cable (supplied) to a computer. Connect the USB cable to
the e-mark and computer.
Fig. 37: USB connection
The computer software can be downloaded free of charge from the COLOP homepage
(www.emark.colop.com).
5.9 Storage
Store the product in a dry place. When storing the e-mark, always place in the docking station to prevent
drying out the print head. Store batteries only when charged.
When stored for extended periods, keep it in the original packaging (see chapter 4.1) or in the additionally
available transport case to protect it. It is recommended to activate the e-mark at least once a month to
prevent the print head from completely drying out. Batteries should be charged, if required (see chapter
6.1). Complete the self-cleaning process and make a test imprint (see chapter 5.2). In the event the test
imprint quality is poor, complete a manual cleaning cycle (see chapter 5.5).
Always place the e-mark in the docking station during storage. It is
recommended to activate the e-mark at least once a month and to complete
the automatic cleaning process (or manual cleaning process, if required).
To Next Page
Loading...
