e-mark marking device Chapter 1 Introduction
CODI Standard 1.0 Page 6 of 61
Operating and Maintenance Manual
1 INTRODUCTION
With the COLOP e-mark marking device you have a product that is exemplary in terms of safety for users
and leading edge in terms of technology. In spite of this, the e-mark may be hazardous if used incorrectly
or not as intended. We refer to potential hazards in Section 2 ‘Safety’ and with safety notices throughout
the entire documentation.
Preface
This original documentation is intended to assure safety-aware work on and with the product. It contains
safety notices that must be followed! Everybody who works with the e-mark must have access to this
documentation and must observe the relevant specifications and instructions. The documentation must
always be complete and easily legible.
COLOP Digital GmbH is not liable for technical or printing-related defects in this documentation, nor will it
accept any liability for damage caused directly or indirectly by the delivery, performance or usage of this
documentation.
Identification
The product is clearly identified on the packaging.
CE mark in accordance with Directive 2014/35/EU (Low-Voltage Directive)
1.1 Legal details
COLOP Digital GmbH
Dr.-Arming-Straße 5
A-4600 Wels
Austria
Phone: +43 (0) 7242 661 04
Fax: +43 (0) 7242 466 64
E-Mail: emark@colop.co.at
Website: https://emark.colop.com/
To Next Page
Loading...
