e-mark marking device Chapter 6 Maintenance
CODI Standard 1.0 Page 53 of 61
Operating and Maintenance Manual
ALWAYS place the e-mark in the docking station after use. Otherwise, the ink
cartridge head dries out, affecting print quality. A warning signal sounds if the
e-mark is switched on and not placed in the docking station immediately.
Return the e-mark to the docking station. If the e-mark is switched off, NO
warning signal sounds, but the e-mark should always be placed in the docking
station even if switched off.
Tip: Always place the e-mark in the docking station first and then switch it off.
Cleaning could make electrical components damp, causing injury to
people through electric shock.
During cleaning work, avoid any ingress of water, steam or cleaning agent in
the electrical components of the product.
Wipe down the product with a damp cloth.
All cleaning work on the product must be carried out by people who have read this Operating and
Maintenance Manual and who are informed of the hazards that can result from this product.
For cleaning purposes, the product can be vacuumed, brushed or wiped with a damp cloth that does not
contain an aggressive cleaning agent.
Regardless of general cleaning activities, the following cleaning operations must be performed at the
stipulated intervals:
Daily and/or after every time in use
Every week or as required
To Next Page
Loading...
