ComAp IM-NT - Page 201

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
201
12.2.14.14 Setpoint: AcallCH5-Type
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Force value
possible
YES
Description
The setpoint is used to specify the alert type of the active calls - channel 5.
See the chapter Alarm messaging for more details.
12.2.14.15 Setpoint: AcallCH5-Addr
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Description
The setpoint is used to specify the recipient address for the active calls -
channel 5. The content of the address must correspond to the selected alert
type (e.g. it must contain e-mail address if the alert type is e-mail). See the
chapter Alarm messaging for more details.
12.2.14.16 Setpoint: NumberRings AA
Group
Act. calls/SMS
Range [units]
1 .. 30 [-]
Related FW
3.0
Description
This setpoint is used to adjust the number of rings after which the modem,
which is attached to he controller, answers the incoming call.
Number of rings prior to answering the modem connection from PC to
controller.
NOTE:
Any change of this setpoint is applied first after next switching the controller
or modem off and on or after disconnecting the modem from the controller
and connecting it back.