InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
4.1.3 Internet connection
Internet (Ethernet) connection can be used directly in NTC BaseBox version of the controller. For
connection to other versions, use IntenetBridge-NT device. Figures below illustrate the connection
setting in GenConfig and InteliMonitor.
Adjust IP address of the controller (InternetBridge) you want to connect to. Select CAN address of the
controller. Enter Access Code for remote connection. Enter password (optional for locked
configuration).
NOTE:
The controller must have public IP address or it must be reachable for connection in the specific
network.
To Next Page
Loading...
Need help?
General
