ComAp IM-NT - Page 203

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
203
12.2.15.2 Setpoint: Time Stamp Per
Group
Date/Time
Range [units]
1 .. 240 [min]
Related FW
3.0
Description
The setpoint adjusts the time interval for Time stamp records. See also the
setpoint Time stamp act.
12.2.15.3 Setpoint: #SummerTimeMod
Group
Date/Time
Range [units]
DISABLED, WINTER, SUMMER, WINTER-S, SUMMER-S [-]
Related FW
3.0
Description
The setpoint is used to select the mode of automatic daylight saving time
change.
DISABLED
The automatic change to daylight saving time and back is
disabled.
WINTER
The automatic change is enabled, the current season is
winter and the controller is located in the northern
hemisphere.
SUMMER
The automatic change is enabled, the current season is
summer and the controller is located in the northern
hemisphere.
WINTER-S
The automatic change is enabled, the current season is
winter and the controller is located in the southern
hemisphere.
SUMMER-S
The automatic change is enabled, the current season is
summer and the controller is located in the southern
hemisphere.
NOTE:
# sign in the name of this setpoint marks that this setpoint is shared among
all controllers connected by CAN2 bus.