ComAp IM-NT - Page 211

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
211
13.1.1.25 Value: BusL V
Group
BusL values
Units
V
Related FW
3.0
Description
BusL voltage. Average from all three phases.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint VbL VT ratio.
13.1.1.26 Value: BusL V L1-L2
Group
BusL values
Units
V
Related FW
3.0
Description
BusL voltage between phase L1 and phase L2.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint VbL VT ratio.
13.1.1.27 Value: BusL V L2-L3
Group
BusL values
Units
V
Related FW
3.0
Description
BusL voltage between phase L2 and phase L3.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint VbL VT ratio.