ComAp IM-NT - Page 232

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
232
13.1.8.3 Value: AIN CU-1
Group
Analog CU
Units
configurable
Related FW
3.0
Description
This is the value of the analog input 1 of the controller. Analog inputs are fully
configurable so the name and units depend on configuration. In the default
configuration the input is used for oil pressure measurement.
13.1.8.4 Value: AIN CU-2
Group
Analog CU
Units
configurable
Related FW
3.0
Description
This is the value of the analog input 2 of the controller. Analog inputs are fully
configurable so the name and units depend on configuration. In the default
configuration the input is used for water temperature measurement.
13.1.8.5 Value: AIN CU-3
Group
Analog CU
Units
configurable
Related FW
3.0
Description
This is the value of the analog input 3 of the controller. Analog inputs are fully
configurable so the name and units depend on configuration. In the default
configuration the input is used for fuel level measurement.
13.1.8.6 Value: AIN CU-4
Group
Analog CU
Units
configurable
Related FW
3.0
Description
This is the value of the analog input 4 of the controller. Analog inputs are fully
configurable so the name and units depend on configuration. In the default
configuration the input is used for fuel level measurement.