InteliMains 210 Global Guide
274
Setpoint group
CM-GPRS; CM-4G-
GPS; CM-Ethernet
Related FW 2.0.0
Range [units] 0 .. 65 535[-]
Default value 23 Alternative config NO
Step [-]
Comm object 24374 Related applications MCB, MGCB, BTB
Description
This setpoint is used to adjust the port number, which is used for Ethernet connection to a PC with any of
ComAp PC program (i.e. InteliConfig). This setpoint should be adjusted to 23, which is the default port used
by all ComAp PC programs. A different value should be used only in special situations as e.g. sharing one
public IP address among many controllers or to overcome a firewall restrictions.
IMPORTANT: If AirGate is used, this setpoint has to be adjusted to 23.
Note: This setpoint is common for CM-Ethernet, CM-GPRS and CM-4G-GPS modules.
ComAp TCP Port
6 back to List of setpoints
Group: CM-4G-GPS
Setpoint group
CM-GPRS; CM-4G-
GPS
Related FW 2.0.0
Range [units] Email+SMS / SMS Only [-]
Default value Email+SMS Alternative config NO
Step [-]
Comm object 24315 Related applications MCB, MGCB, BTB
Description
This setpoint adjust the communication mode of module.
Email+SMS
Controller is connected to the Internet and is able to send e-mails as well as SMS. The
controller is also accessible via AirGate. Internet-enabled SIM card must be used. Also
APN Name (page 275) has to be adjusted.
SMS Only Only SMS are sent. Internet-enabled SIM card is not required.
IMPORTANT: When this setpoint is changed the controller has to be restarted to apply
changes.
Mode
6 List of setpoints (page 165)
To Next Page
Loading...
Need help?
General
