ComAp InteliMains 210 BTB User Manual

InteliMains 210 Global Guide
273
Setpoint group
CM-GPRS; CM-4G-
GPS
Related FW 2.0.0
Range [units] Valid IP address [-]
Default value [-] Alternative config NO
Step [-]
Comm object 24314 Related applications MCB, MGCB, BTB
Description
The setpoint is used to adjust the domain name server (DNS), which is needed to translate domain names in
email addresses and server names into correct IP addresses.
DNS IP Address
6 List of setpoints (page 165)
Setpoint group
CM-GPRS; CM-4G-
GPS
Related FW 2.0.0
Range [units] DISABLED / ENABLED [-]
Default value ENABLED Alternative config NO
Step [-]
Comm object 24273 Related applications MCB, MGCB, BTB
Description
This setpoint enable or disable AirGate connection via CM-GPRS or via CM-4G-GPS.
DISABLED: Only SMS are sent. Internet-enabled SIM card is not required. AirGate is not used.
ENABLED This mode uses the “AirGate” service. Internet-enabled SIM card must be used. The
AirGate server address is adjusted by the setpoint AirGate Address (page 293).
IMPORTANT: When this setpoint is changed the controller has to be restarted to apply
changes.
AirGate Connection
6 back to List of setpoints
Setpoint group
CM-GPRS; CM-4G-
GPS; CM-Ethernet
Related FW 2.0.0
Range [units] [-]
Default value airgate.comap.cz Alternative config NO
Step [-]
Comm object 24364 Related applications MCB, MGCB, BTB
Description
This setpoint is used for entering the domain name or IP address of the AirGate server. Use the free AirGate
server provided by ComAp at airgate.comap.cz.
Note: This setpoint is common for CM-Ethernet, CM-GPRS and CM-4G-GPS modules.
AirGate Address
6 back to List of setpoints

ComAp InteliMains 210 BTB Specifications

General

Brand	ComAp
Model	InteliMains 210 BTB
Category	Controller
Language	English