InteliMains 210 Global Guide
293
Setpoint group CM-Ethernet Related FW 2.0.0
Range [units] Valid IP address [-]
Default value DISABLED Alternative config NO
Step [-]
Comm object 24293 Related applications MCB, MGCB, BTB
Description
IP address 2 for receiving SNMP Traps. Leave this setpoint blank if SNMP traps should not be send.
SNMP Traps IP Address 2
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 2.0.0
Range [units] DISABLED / ENABLED [-]
Default value ENABLED Alternative config NO
Step [-]
Comm object 24365 Related applications MCB, MGCB, BTB
Description
This setpoint selects the Ethernet connection mode.
DISABLED: This is a standard mode in which the controller listens to the incoming traffic and answers
the TCP/IP queries addressed to it. This mode requires the controller to be accessible
from the remote device (PC), i.e. it must be accessible at a public and static IP address if
you want to connect to it from the internet.
ENABLED This mode enables the AirGate service. The AirGate server address is adjusted by the
setpoint AirGate Address (page 293). Also the standard TCP/IP is enabled.
AirGate Connection
6 back to List of setpoints
Setpoint group
CM-GPRS; CM-4G-
GPS; CM-Ethernet
Related FW 2.0.0
Range [units] [-]
Default value airgate.comap.cz Alternative config NO
Step [-]
Comm object 24364 Related applications MCB, MGCB, BTB
Description
This setpoint is used for entering the domain name or IP address of the AirGate server. Use the free AirGate
server provided by ComAp at airgate.comap.cz.
Note: This setpoint is common for CM-Ethernet, CM-GPRS and CM-4G-GPS modules.
AirGate Address
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
