InteliMains 210 Global Guide
279
Setpoint group
CM-GPRS; CM-4G-
GPS
Related FW 2.0.0
Range [units] 0..31 characters [-]
Default value [-] Alternative config NO
Step [-]
Comm object 24310 Related applications MCB, MGCB, BTB
Description
Enter an existing email address into this setpoint. This address will be used as sender address in active e-
mails that will be sent from the controller.
Note: It is not needed to enter an existing email address, nevertheless valid email format needs to be
followed.
IMPORTANT: This item is obligatory when emails are configured.
SMTP Sender Address
6 back to List of setpoints
Setpoint group
CM-GPRS; CM-4G-
GPS; CM-Ethernet
Related FW 2.0.0
Range [units] GMT-12:00 .. GMT+13:00 [hours]
Default value GMT+1:00 hour Alternative config NO
Step [-]
Comm object 24366 Related applications MCB, MGCB, BTB
Description
This setpoint is used to select the time zone where the controller is located. See your computer time zone
setting (click on the time indicator located in the rightmost position of the Windows task bar) if you are not
sure about your time zone.
Note: If the time zone is not selected properly the active e-mails may contain incorrect information about
sending time, which may result in confusion when the respective problem actually occurred.
Note: This setpoint is common for CM-Ethernet, CM-GPRS and CM-4G-GPS modules.
Time Zone
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
