Comdial DX-80 - Sending a Call Me Message

October, ‘03 Comdial 91
DX-80 Installation & Maintenance
The following screen shows the results of the COM4 board diagnostics.
4. To exit the report screens, press the ESC key. When prompted Exit This Feature?, select Yes.
3.6.3 STATUS
You can use the Status function to view a specific DX-80 system resource status.
1. Move the cursor to the system resource to view, and press Enter.
No loop current detected
Other possible codes:
- Passed = Loop OK
- In = Incoming Call
- Out = Outgoing Call
- Failed = Loop Fail
- Open = Not Equipped