Comen N Series - Page 4

Service Manual for N-series/NM-series/NMPro-series Patient Monitors
3
4.6.8 IBP Failures 4-8
4.6.9 CO
2
Failures 4-8
4.6.10 Software Upgrade Problems 4-9
4.6.11 Technical Alarm Messages 4-9
Chapter 5 Software upgrade 1
5.1 Preparation before Upgrade System Software 5-1
5.2 System Software Upgrade 5-1
Chapter 6 Performance Verification, Calibration 1
6.1 NIBP Test 6-1
6.1.1 NIBP Leakage Test 6-1
6.1.2 IBP Pressure Calibration 6-1
6.2 IBP Test 6-2
6.3 ECG Test 6-2
6.4 TEMP Test 6-3
6.5 SpO
2
Test 6-3
6.6 CO
2
Test 6-3
Chapter 7 Maintenance and Disassembly 1
7.1 Tools 7-1
7.2 Disassembly preparation 7-1
7.3 Remove plug-in box 7-2
7.4 Remove the battery 7-2
7.5 Remove the rear housing 7-3
7.6 Remove infrared transmitting board 7-5
7.7 Remove the main board 7-5
7.8 Remove the AC power board 7-6
7.9 Remove the parameter board 7-7
Chapter 8 Components 8-1
8.1 Introduction 8-1
8.2 Exploded view (Take N12 and N12M as examples) 8-1
8.2.1 N12 exploded view 8-1
8.2.2 N12Mexploded view 8-2