Comet CBM Series User Manual

29
USING AND LOOKING AFTER THE MANUAL
WARNING
• This manual completes any other provided for any combustion engine equipping the machine: read both
manuals carefully.
• The manual of any combustion engine equipping the machine must always accompany this manual.
The manual must be deemed an integral part of the machine and must be looked after for future reference
and kept in a protected place where it can easily be referred to in case of need.
The manual contains safety precautions for the operator and those surrounding him/her and for the protection
of the environment.
In case of deterioration or loss, a new copy must be requested from the Manufacturer or from a
SKILLED
TECHNICIAN
.
In the event of the machine being transferred to another user, please also include this manual and any manual
for the combustion engine equipping the machine.
The Manufacturer reserves the right to make all the amendments required to update and correct this
publication without prior notice.
SYMBOLS
The symbol: WARNING
marking certain parts of the text indicates a likely chance of injury to persons unless the relative prescriptions
and indications are followed.
The symbol: CAUTION
marking certain parts of the text indicates the possibility of damaging the machine unless the relative
instructions are followed.
SPECIFICATIONS AND TECHNICAL DATA
Barrows (just one wheel) and trolleys (two wheels) have a tubular steel bearing frame, a polyethylene tank,
rubber hoses, a lance for spraying and a motor pump with either an electric motor or combustion engine.
They can be tted with a hose reel (optional).
In the following table reference can be made to the motor pump tted on the machine when necessary.
Machines
with electric motor
Machines
with combustion engine
POWER SUPPLY/FUEL Power voltage, frequency and power are
shown on the plate (37/45).
The fuel to be used is shown in the
engine manual.
PUMP OIL
• MTP MC 8 - MTP MC 18 ENI Blasia S 150
• Remaining pumps Comet “C1 OIL”
REDUCTION GEAR LUBRICANT
• MTP MC 8 - MTP MC 18 — Grease “ENI Grease MU EP”
• Remaining pumps Comet “C1 OIL”
HYDRAULIC CONNECTION
Max water supply temperature 40 °C - 104 °F
Min water supply temperature 5 °C - 41 °F
Max water supply pressure 0,01 MPa - 0,1 bar - 1,45 psi
Max priming depth:
• MTP MC 8 - MTP MC 18 - MTP MC 20/20 MTP MC 25 1,0 m - 3,3 ft
• Remaining pumps 1,0 m - 3,3 ft (3,0 m - 9,8 ft for periods of no longer than 10-15 min)
Min water supply ow rate 1,3 x max motor pump ow rate
(continued on next page)
EN

Comet CBM Series Specifications

General

Brand	Comet
Model	CBM Series
Category	Control Unit
Language	English