37
BEND NOT FOUND
38
LINE# TOO LARGE
39
UNRESOLVED
REFERENCE
40
41
UNIMPLEMENTED
COMMAND
FILE READ
The program encountered
an “ IF...THEN BEGIN “ or
“ IF...THEN...ELSE BEGIN”
construct, and could not
find a BEND keyword to
match the BEGIN.
An error has occurred in
renumbering a BASIC
program. The given
parameters result in a
line number > 63999 being
generated; therefore, the
renumbering was not
performed.
An error has occurred in
renumbering a BASIC pro
gram. A line number referred
to by a command (e.g., GOTO
999) does not exist.
Therefore the renumbering
was not performed.
A command not supported by
BASIC 7.0 was encountered.
An error condition was
encountered while loading
or reading a program or
file from the disk drive
(e.g., opening the disk
drive door while a program
was loading).
A-5
To Next Page
Loading...
