ComNav 1500 / 1510 Autopilot - 33 -
6. SETUP
6.1 Setup Mode
To get the most out of your 1500 or 1510 Autopilot, it is important to carefully setup
and calibrate your Network. The settings are stored in a non-volatile memory, which
means they will remain in memory after you have turned off the power. To get an
overview of your Network settings, we recommend that you note your settings.
6.1.1 Setup Mode Divided into 4 Setup Groups
[Lit OFF] = Lighting setup group
[P0] - [P9] = Pilot setup group
[A0] - [A4] = Alarm setup group
[C0] - [C6] = Compass setup group
6.1.2 Access Setup Mode
To access setup mode, press and hold MODE more than 2
seconds.
To move to next setup group, press MODE.
To scroll up and down in each group press LEFT or RIGHT.
6.1.3 Change a Setting
To unlock a setting, press SET.
To change a setting, press LEFT, RIGHT and MODE as required.
To lock a setting, press SET.
6.1.4 Return to Previous Mode
To return to previous mode, press SET when the text return [RET]
is displayed.
6.1.5 Factory Default Settings
After each setting we have listed the factory default settings. This allows you to
manually get back to factory default settings, if needed. There is no automatic way
to get back to factory default settings, it has to be done manually.
All Autopilot instrument settings are central, and affect all connected Autopilot
instruments and their commands.
Note! The APC routine automatically sets these settings:
[RUD], [SEA], [CRD], [ATC] and [RRS].
Therefore these settings and their minimum and maximum values
and times, depend on how your boat behaves.
To Next Page
Loading...
