ComNav 1500 - NX2 Network Error Messages

ComNav 1500 / 1510 Autopilot - 53 -
10.3 NX2 Network Error Messages with Cause and Remedy
If an error message [Err #] is displayed, an error has been detected by the NX2
Network. The message can assist you to diagnose the cause and remedy the error.
To escape from an error message, press any push-button. If not possible to
escape, reset power (turn off and on again), then remedy the situation as
suggested below.
Note! For errors marked with [*], contact your ComNav dealer or the factory in
order to return the unit for rectification.
NO. MESSAGE AND CAUSE REMEDY *
01 Activated watchdog timeout Reset power.
*
02 NX2 Network data frames are
missing.
Check connections and setup.
03 No data received within approx. 10
sec.
Check connections.
04 EEPROM read. Reset power.
*
05 EEPROM write. Reset power.
*
06 RAM memory error. Reset power.
*
07 Auto-log full, in GPS Compass. Clear Auto-log memory.
08 Break reset. Reset power.
*
09 EEPROM auto initiation, or NMEA
transmit fail. (NX2 Server only).
Reset power.
*
10 Range error, input e.g. 17° 70’ = too
many minutes.
Correct input format.
11 Remote control setup error.
Command can not be executed.
Check connections and settings.
12 No response from Navigator Check navigator connection and
settings.
13 Waypoint not defined. Define a waypoint.
14 Impossible command when used
with an external NMEA navigator.
Use only possible command.
15 Impossible command when in
Autopilot mode.
Use only possible commands.
16 Auto-deviation is not possible. Check for extreme magnetic field,
upside down mounting of
transducer or wrong transducer
type.
17 Auto-deviation check failed. 1-¼ turn not complete or extreme
magnetic disturbance.
18 Auto-deviation. Function denied. Function denied since compass is
busy with the Auto-deviation
routine.