SinoGNSS
○
R
T300 User Guide
10
Storage of the Lithium-ion Battery
– Do not keep batteries inside the receiver if the receiver not used for long time.
– Keep batteries in dry conditions.
– Take out the batteries from receiver for shipment.
Dispose of the Lithium-ion Battery
– Discharge a Lithium-ion battery before dispose of it.
– Dispose of batteries is an environmentally sensitive manner, and adhere to any
local and national regulations concerning battery disposing or recycling.
WARNING – Do not damage the rechargeable Lithium-ion battery. A damaged battery can
cause an explosion or fire, and can result in personal injury and/or property damage.
2.4.2 External Power Supply
The receiver is connected to an external power supply through a lemo to RS232
cable, and make sure that the red alligator clip is connected to the positive of
external power supply, black one to negative. Over-voltage function cannot
protect your T300 receiver if reverse connection.
Tip: The power consumption will be increasing if the base station transmits correction data
through internal UHF in the RTK mode; therefore, we strongly suggest using external power
(7-28 volt DC) for the base station.
2.5 Pole-mounted setup
To mount the receiver on a range pole as the figure shown below:
To Next Page
Loading...
