SinoGNSS
○
R
T300 User Guide
14
5. Complete all configurations and click Apply Settings to save settings. Exit and
restart the receiver to activate configurations.
4.2 Static Data Collection
Static survey is mainly used for the control survey. To reach millimeter accuracy,
follow guidelines below:
At least 3 GNSS receivers are required to form a stable triangulation network.
It is better to set Data Log Session as manual on the known point.
Power off the receiver before moving to other observation site.
To quickly post-process static observation raw data, write down the station
name, receiver SN, antenna height, start and end time for each observation
site.
4.3 Static data management
This section consists of raw data download, RINEX format conversion and memory
management for T300 receiver.
4.3.1 Raw Data Download
The raw observation data is commonly saved in internal memory of T300 receiver,
download data from receiver to your PC through CRU software.
1. Connect the T300 receiver to your PC as described before (see Chapter 4.1).
2. Click Folders to select download path
3. Click File Download in project menu to check all raw data on main window, or
To Next Page
Loading...
